| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Templates? http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=5793 |
Page 1 of 1 |
| Author: | Iplaytheoldies [ Thu Mar 23, 2006 2:12 pm ] |
| Post subject: | |
Is there anyone on the forum that sells a set of plexiglass or wood templates for a tenon neck joint? I found the ones at stew mac but was just wondering if anyone else had them? |
|
| Author: | A Peebels [ Thu Mar 23, 2006 3:06 pm ] |
| Post subject: | |
I just made my own from plywood. Al |
|
| Author: | peterm [ Fri Mar 24, 2006 4:10 am ] |
| Post subject: | |
Me too, 1/2 or 3/4" plywood works great. And that way you can make your own size or shape. Remember you will need to angle the cut to match the neck angle at the body. |
|
| Author: | Iplaytheoldies [ Fri Mar 24, 2006 5:03 pm ] |
| Post subject: | |
It's the angle part that makes me want to buy a template rather than build one. It will probably end up costing me more in time and money with trial and error vs. picking one up that somebody else has already perfected. |
|
| Author: | Red Ennis [ Fri Mar 24, 2006 10:54 pm ] |
| Post subject: | |
Hey, I'd like a set of those. |
|
| Author: | ctholden [ Sat Mar 25, 2006 1:53 am ] |
| Post subject: | |
It's not the template that puts the angle on the neck, it's the jig that the template goes on that makes the angle on it. Plans are available on the forum here for Paul Woolson's version of the jig, but if you don't want to build it yourself, I build and sell the jig with the tenon template. I don't sell the mortise template because it is just a 3/4" rout, but can do so. Craig CT Holden Luthiery and Supplies, Inc. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|